Configuring Tcp/Ipv6 Network Settings - Canon iPF6400S User Manual

Hide thumbs Also See for iPF6400S:

Table of Contents

Press the OK button.

The Set./Adj. Menu is displayed.

Press ▲ or ▼ to select Interface Setup, and then press the OK button.

Press ▲ or ▼ to select Ethernet Driver, and then press the OK button.

Press ▲ or ▼ to select MAC Address, and then press the OK button.

If the Tab Selection screen is not displayed, press the Menu button.

You can investigate the MAC address by printing an interface setting report.

(See "Printing Interface Setting Reports.")

In Windows, open a command prompt, or in Mac OS X, start Terminal.

Execute the following command to add entries to the ARP table for managing IP addresses and corre-

sponding MAC addresses.

arp -s [IP address] [the printer's MAC address you have verified]

Example: arp -s xxx.xxx.xxx.xxx xx-xx-xx-xx-xx-xx

In Mac OS X when using Terminal, enter the arp command in the format

arp -s xxx.xxx.xxx.xxx xx-xx-xx-xx-xx-xx.

For details, refer to the help file for the command line.

Execute the following command to send the IP address to the printer and configure it.

ping [IP address as specified in the ARP command] -l 479

Example: ping xxx.xxx.xxx.xxx -l 479

In -l, the l is the letter l.

In Mac OS X when using Terminal, enter the ping command in the format

ping -s 479 xxx.xxx.xxx.xxx.

For details, refer to the help file for the command line.

The subnet mask and default gateway are set to 0.0.0.0. Use RemoteUI to change the subnet mask and default gateway

to match your network settings.

For details on RemoteUI, see "Using RemoteUI."