Canon iPF6400S User Manual page 588

Menu Settings
Paper Details
Paper Details
Keep Paper Type
*1: For information on the types of paper the printer supports, refer to the Paper Reference Guide. (See "Displaying the Paper Refer-
ence Guide.")
when you install the printer driver from the User Software CD-ROM or if you update paper information with the Media Configuration
Tool. (See "Updating paper information.")
Ink Menu
588
Rep. Ink Tank
Head Cleaning A
Setting Item
(The type of paper
CutDustReduct.
is displayed here.)
( *1 )
VacuumStrngth
Scan Wait Time
Roll DryingTime
NearEnd
RollMrgn
NearEnd Sht
Mrgn
BordlessOversize
Manual Feed
Return Defaults
Types of paper in the printer driver and related software (as well as on the Control Panel ) are updated
P.464
➔
P.467
➔
Setting Item
Description, Instructions
If you choose On, a line will be printed at the cut position when paper
cutting is selected. This option reduces the amount of debris given off
after cutting. It also helps prevent adhesive from sticking to the cutter
and keeps the cutter sharp if you use adhesive paper. (See "Reduc-
ing Dust from Cutting Rolls.")
P.491
➔
Specify the level of suction that holds paper against the Platen. (See
"Adjusting the Vacuum Strength.")
Specify the time to wait for the ink to dry between each scan (after
the printhead finishes moving in one direction), in consideration of
how quickly the ink dries. Also specify the applicable area for the ink
drying time. Select Entire area to apply the ink drying time after each
scan until the document is fully printed. Select Leading edge to apply
the ink drying time after each scan only in the area 110–140 mm from
the leading edge. (The applicable length varies depending on the
Print Quality setting.) Note that printing will take longer if you specify
the Scan Wait Time setting. In particular, when Leading edge is se-
lected, colors may be uneven in the boundary between the areas with
and without a drying time.
Specify the time to wait for the ink to dry for each sheet.
Specify the minimum margin at the leading edge of roll paper to en-
sure better printing quality at the leading edge.
Note that if you choose 3mm, it may lower the printing quality at the
leading edge and affect feeding accuracy. The printed surface may
be scratched, and ink may adhere to the leading edge. It may also
cause the Platen to become soiled.
Specify a margin at the leading edge of sheets to ensure better print-
ing quality at the leading edge.
Note that if you choose 3mm, it may lower the printing quality at the
leading edge and affect feeding accuracy. The printed surface may
be scratched, and ink may adhere to the leading edge.
Select the amount of oversize extension of the original during border-
less printing.
Normally, we recommend that you set this to Standard.
If it is set to Little, although it will reduce soiling on the back surface,
white patches may remain on the printed surface.
Select the Paper Feed Slot to use when printing on sheets. Normally,
select Top. When printing on heavyweight paper such as POP
Board, select Front.
Choose OK to restore Paper Details to the default values.
Print the paper settings as specified in Paper Details.
Select On when printing on a particular type of paper regularly. (See
"Changing the Type of Paper.")
Description, Instructions
Replace the Ink Tank at this point. Follow the instructions dis-
played to complete the required procedure. (See "Replacing Ink
Tanks.")
P.816
➔
Printhead cleaning options. (See "Cleaning the Print-
head.")
P.825
➔
iPF6400S
P.721
➔
P.476
➔
User's Guide