Samsung SRP-275 Operator's Manual page 99

CHAPTER 5
CONTROL COMMANDS LIST
Command Code
Specifying the double width
SO 0E
character
Canceling the double width
SI 0F
character
Command Code
DC1 11 Selecting the printer
DC2 12 Specifying the red print
DC3 13 Deselecting the printer
ESC "C" n 1B 43 n Setting the page length
5-124
Function
8-bit data selected 7-bit data selected
Specifying the shift-out side
character
Specifying the shift-in side
character
Function
5.4.6 Commands description CITIZEN mode (iDP3550/3551)
FF n
[Name] n-line paper feed
[Format] ASCII FF n
Hex 0C n
≤ n ≤ 127
[Range] 1
[Description] This command feeds the paper by n-lines. You can set n = 1 to 127 lines.
If the print buffer contains the data, use of this command feeds the paper
by n-lines after printing the data. Setting n = 0 does not feed the paper.
FF
[Name] Form feed
[Format] ASCII FF
Hex 0C
[Description] This command searches for the beginning of the next page after printing the
data in the print buffer
SO
[Name] Specifying the double width character
[Format] ASCII SO
Hex 0E
[Description] The data following this command is printed doubled in the horizontal direction.
Double width characters remain valid until the double width character cancel
command is entered, but they are also cancelled after they are printed one
line. Note that the double width characters take up two ordinary characters
worth of width.
(CBM1 Mode)
(CBM2 Mode)
(CBM1 Mode)
5-125