Commands Description For Epson Mode (Tm-U220) - Samsung SRP-275 Operator's Manual

CHAPTER 5
CONTROL COMMANDS LIST
5.4.2

Commands description for Epson mode (TM-U220)

HT
[Name] Horizontal tab
[Format] ASCII HT
Hex 09
Decimal 9
[Range] None
[Default] None
[Description] Moves the printing position to the next horizontal tab.
[Notes] This command is ignored unless the next horizontal tab position
has been set.
Horizontal tab positions are set by ESC D.
If the next horizontal tab position exceeds the printing area,
the printer sets the printing position to [Printing area width + 1].
When underline mode is turned on, the underline will not be printed
under the tab space skipped by this command.
LF
[Name] Print and line feed
[Format] ASCII LF
Hex 0A
Decimal 10
[Range] None
[Default] None
[Description] Prints the data in the print buffer and feeds one line.
[Notes] The amount of paper fed per line is based on the value set using the
line spacing command (ESC 2 or ESC 3).
After printing, the printing position moves to the beginning of the line.
5-6
CR
[Name] Print and carriage return
[Format] ASCII CR
Hex 0D
Decimal 13
[Range] None
[Default] None
[Description]
When auto line feed is enabled (DSW 2-1)
(Only available with Parallel Interface)
Executes printing and one line feed as LF
[Notes] With a serial interface, the command performs as if auto line feed is
disabled.
With a parallel interface, enabling or disabling the auto line feed can be
selected by the DIP Switch (DSW2-1).
After printing, the printing position moves to the beginning of the line.
When auto line feed is disabled
Prints data in print buffer and does not feed the
paper
5-7