Changing The Dip Switch Setting - Samsung SRP-275 Operator's Manual

CHAPTER 3
Switch settings
Memory Switch 4
Bit Function
F~9
8 Automatic status function
7~4
3 ESC RS a n command function
2~1
0 Data reception error (serial)
Memory Switch 5
Bit Function
F~0 Reserved
Memory Switch 6
Bit Function
F~A
9 BUSY Condition
8~0
Memory Switch 7
Bit Function
F~0 Reserved
3-18
0 1
Disabled Enabled
Only setting Auto-status sent only once
Prints "?" Ignored
0 1
0 1
Reception Buffer or Offline Reception Buffer Full
0 1

3.3 Changing the DIP Switch setting

If you need to change settings, follow the steps below to make your changes.
Turn off the printer before removing the DIP Switch cover to prevent an electric short,
which can damage the printer.
1) Make sure the printer is turned off.
2) Remove the screw from the DIP Switch cover.
Then take off the DIP Switch cover, which is shown in the illustration below.
3) Set the switches using a pointed tool, such as tweezers or a small.
4) Replace the DIP Switch cover. Then secure it with the screw.
The new settings take effect when you turn on the printer.
3-19 3-19