Samsung SRP-275 Operator's Manual page 81

CHAPTER 5
CONTROL COMMANDS LIST
ESC J n
[Name] Execute n/72 inch paper feed one time
[Format] ASCII ESC
Hex 1B
Decimal 27
1 ≤ n ≤ 255
[Range]
[Default] ------
[Description] After printing data in the line buffer, paper is fed n/72 of an inch in the paper
feed direction. Line feed amount is unaffected even if double-high characters
and double-high/wide characters exist in the same line.
The single line feed setting value is not changed by this command.
ESC I n
[Name] Execute n/144 inch paper feed one time
[Format] ASCII ESC
Hex 1B
Decimal 27
1 ≤ n ≤ 255
[Range]
[Default] ------
[Description] After printing data in the line buffer, paper is fed n/144 of an inch in the paper
feed direction. Line feed amount is unaffected even if double-high characters
and double-high/wide characters exist in the same line.
The single line feed setting value is not changed by this command.
5-90
J n
4A n
74 n
I n
49 n
73 n
FF
[Name] Form feed
[Format] ASCII FF
Hex 0C
Decimal 12
[Range] ------
[Default] ------
[Description] This command performs the following operations after the printer prints the
printing data in the line buffer.
Operations are set by the Memory Switch
MSW Cutter model
Condition 1 Executes a form feed.
Feeds paper to the cutting
Condition 2
position and performs a full cut.
(*1)
Condition 3 Executes a form feed.
Feeds paper to the cutting
position and performs a partial
Condition 4
cut. (*1)
(*1) Paper feed to cutting position: Executes a 1 inch paper feed.
(*2) Paper feed to tear-bar position: Executes a 7/6 inch paper feed.
Refer to the explanations on memory switches in each of the printer's
product specification manuals for details regarding Memory Switch settings.
Tear-bar model
Executes a form feed.
Paper is fed to the tear-bar
position. (*2)
Executes a form feed.
Paper is fed to the tear-bar
position. (*2)
5-91