Samsung SRP-275 Operator's Manual page 85

CHAPTER 5
CONTROL COMMANDS LIST
HT
[Name] Move horizontal tab
[Format] ASCII HT
Hex 09
Decimal 9
[Range] ------
[Default] ------
[Description] Move print position to next horizontal tab position.
The current moves to the next tab position when at the horizontal tab position.
This command is ignored with under the following conditions.
- When there is no horizontal tab set :
- When the current position is the same as the furthest right horizontal
tab position or to the right of it.
In the underline/upperline modes, underlines and upperlines are not
printed in the spaces created by a horizontal tab.
5-98
ESC D n1 n2 nk NUL
[Name] Set horizontal tab
[Format] ASCII ESC D
Hex 1B 44
Decimal 27 68
1 ≤ n ≤ Maximum printable digits ≤ 255
[Range]
0 ≤ k ≤ 16
[Default] (Not set)
[Description] Uses the left edge as a standard to set the horizontal tab to the position of
current ANK character pitch x n).
The horizontal tab reference point is the left edge of the paper, regardless of
the left margin.
When upside-down printing is specified, the right side becomes the reference.
ANK character pitches, including right spaces, are unaffected by expansion
settings.
All other horizontal tabs set before setting the horizontal tab using this
command are cancelled.
A maximum of 16 horizontal tabs can be set, but the tab position must satisfy
the following conditions.
If the following conditions are not met, data up to the NUL code is discarded.
Normal tabs that meet the conditions below are set and tabs after errors occur
are not set.
- 1 ≤ n1 ≤ n 2 ≤ nk
- nk ≤ Printable region
The horizontal tab set using this command is unaffected by changing the
character pitch.
All horizontal tabs are cleared by inputting ESC D NUL.
n1 n2 nk NUL
n1 n2 nk 00
n1 n2 nk 0
5-99