Unpacking; Choosing A Place For The Printer; Connecting The Cables - Samsung SRP-275 Operator's Manual

CHAPTER 1
Setting up the printer

1.1 Unpacking

Your printer box should include the items shown in the illustration below.
If any items are damaged or missing, please contact your dealer.
SRP-275 A , C
Ribbon Cassette Paper roll

1.2 Choosing a place for the printer

Avoid locations that are subject to direct sunlight or excessive heat.
Avoid using or storing the printer in a place subject to excessive temperature or moisture.
Do not use or store the printer in a dirty location.
When setting up the printer, choose a stable, horizontal location.
Intense vibration or shock may damage the printer.
Ensure the printer has enough space to be used easily.
1-2
AC adaptor Power cord
Quick reference sheet Operator's manual

1.3 Connecting the cables

Plugging in AC adaptor
Before connecting the printer to the power supply, make sure that the voltage and power
specifications match the printer's requirements. Using an incorrect power supply can
cause serious damage to the printer.
Connect the AC adaptor according to the following procedure.
1) Make sure the printer is turned off.
2) Before inserting the AC adaptor, connect the power cord.
3) Insert the AC adaptor as shown.
4) Plug the AC adaptor cable into the printer's power connector.
5) Plug the power cord into the outlet, and turn on the power.
Connecting the interface cable
Connect the printer to the host ECR (host computer) though an interface cable matching the specification
of the printer and the host ECR (host computer). Be sure to use a drawer that matches the printer's
specification.
Depending on the interface your system uses, either connect the serial, parallel, USB or Ethernet
communication cable to the appropriate connector on the back of the printer. Cables are provided by your
dealer or system installer.
Connect the interface cable according to the following procedure.
1) Turn off printer and the ECR (host computer) host.
2) Plug the interface cable into the interface connector on the printer then fasten the screw on
both sides of the connector.
3) Plug the drawer kick-out cable into the drawer kick-out connector on the printer.
(When removing the drawer kick-out cable, press on the connector's clip while pulling out.)
1-3