Rear End Door Opener Switch Inspection (If Equipped); Replacement Of Transmitter Battery (Other Than Keyless Start Model) - Suzuki 2006 SX4 Service Manual

9F-13 Security and Locks:
Rear End Door Opener Switch Inspection (If
Equipped)
1) Remove rear end door trim.
2) Disconnect rear end door switch coupler.
3) Check that there is continuity between terminals "a"
and "b" when rear end door opener switch (1) is
pushed.
4) Check that there is no continuity between terminals
when rear end door opener switch (1) is not pushed.
If check result is not as specified, replace switch.
"a"
"b"
Replacement of Transmitter Battery (Other than
Keyless Start Model)
S6RW0C9606013
If transmitter becomes unreliable, replace transmitter
battery as follows.
1
I5RW0A960009-02
NOTE
For keyless start model, perform
"Replacement of Remote Controller Battery
in Section 10E" instead of "Replacement of
Transmitter Battery (Other than Keyless Start
Model)".
1) Remove screw (1) and transmitter cover (2).
2) Remove transmitter (3) from transmitter holder (4).
CAUTION
!
Use care not to allow grease or dirt to be
attached on the printed circuit board and the
battery.
3) With tip of flat blade screwdriver put in slot of
transmitter, pry it open.
4) Replace the battery (lithium disc-type CR 1620 or
equivalent battery) so its (+) terminal faces "+" mark
on transmitter.
5) Fit together transmitter (3) and install it into
transmitter holder (4).
6) Install transmitter cover (2) and screw (1).
7) Make sure that door locks can be operated with
transmitter.
NOTE
• To prevent theft, be sure to break the
transmitter before discarding it.
• Dispose of the used battery properly
according to applicable rules or
regulations. Do not dispose of lithium
batteries with ordinary household trash.
S6RW0C9606014
4
3
2
1
I4RS0B960014-01