Rear End Door Lock Assembly Removal And Installation; Rear End Door Lock Assembly Inspection - Suzuki 2006 SX4 Service Manual

Rear End Door Lock Assembly Removal and
Installation
Removal
1) Remove door trim (1) from rear end door panel (2).
2) Disconnect door lock motor lead wire (if equipped).
3) Loosen door latch bolts (1) and remove door latch
assembly (2).
2
Installation
Reverse removal procedure to install rear end door lock
assembly noting the following instruction.
• Tighten rear end door latch bolt to specified torque.
Tightening torque
Rear end door latch bolt (a): 10 N·m (1.0 kgf-m,
7.5 lb-ft)
S6RW0C9606011
2
1
I5RW0A960008-02
1
I4RS0A960017-01
(a)
I4RS0A960018-01
• Adjust door latch striker so that its center aligns with
the center of groove in door latch base.
Tightening torque
Rear end door striker screw (a): 23 N·m (2.3 kgf-
m, 17.0 lb-ft)

Rear End Door Lock Assembly Inspection

• Check that door opens and closes smoothly and
properly.
• Check that door stops in the secondary latched
position properly (preventing door from opening
freely) and that door closes completely in the fully
latched position.
• Adjust door latch striker position referring to "Front
Door Lock Assembly Removal and Installation", if
necessary.
Security and Locks: 9F-12
(a)
I4RS0A960019-01
S6RW0C9606012