Rear Wiper Relay Inspection
1) Check that there is no continuity between terminal
"3" and "4". If there is continuity, replace relay.
2) Connect battery positive (+) terminal to terminal "2"
of relay.
3) Connect battery negative (–) terminal to terminal "1"
of relay.
4) Check continuity between terminal "3" and "4". If
there is no continuity when relay is connected to the
battery, replace relay.
Tightening Torque Specifications
Fastening part
Windshield wiper bolt
Windshield wiper arm nut
Rear wiper motor mounting bolt
Rear wiper nut
Rear wiper arm nut
NOTE
The specified tightening torque is also described in the following.
"Wipers and Washers Components"
Reference:
For the tightening torque of fastener not specified in this section, refer to "Fasteners Information in Section 0A".
S6RW0C9406013
Specifications
Tightening torque
N⋅m
kgf-m
8
18
8
5
8
Wipers / Washers:
"3"
"1"
"2"
"4"
lb-ft
0.8
6.0
1.8
13.0
0.8
6.0
0.5
4.0
0.8
6.0
9D-11
I4RS0A940028-01
S6RW0C9407001
Note