Table of Contents
Advertisement
to configuring Router for your station and software.
The microHAM USB Device Router (Router) program provides a Windows compatible configuration tool for
microHAM USB interfaces and software interface to other Windows applications (logging software, digital
mode software, etc.). The software interface is provided as Virtual Serial Ports.
To configure and use microKEYER with Windows compatible application programs it is necessary to have
installed the USB driver, started the Router, and applied power to microKEYER (turn on the radio). Router
must then be configured to match the requirements of the application (logger or digital mode) software.
installed.
Router must be used to configure microKEYER for proper operation. The device configuration tabs (in the
red rectangle) are used to setup each part of microKEYER.
microHAM © 2010 All rights reserved
Configuring microHAM USB Device Router
microKEYER Status
When the USB driver is installed correctly and microKEYER
is turned on Router will show a device tab with a GREEN
check beside the device name (microKEYER).
When Router shows a YELLOW "X" instead of a green
it means the USB driver is correctly installed but
microKEYER is not turned on.
When Router shows a RED "X" instead of a green
means the device is disconnected and Router does not see
the USB part of microKEYER. This happens when the USB
cable is unplugged or the USB driver is not correctly
Initial Setup
11
,
, it
Advertisement
Table of Contents
