Configuring Microham Usb Device Router - microHAM microKEYER II User Manual

The microHAM USB Device Router (Router) program provides a Windows compatible configuration tool for
microHAM USB Devices (microKEYER II as well as DIGI KEYER, microKEYER, CW Keyer and USB
Interfaces) and software interface to other Windows applications (logging software, digital mode software,
etc.). The software interface is provided as Virtual Serial Ports.
In order to configure and use microKEYER II with Windows compatible application programs, you must be
running Router and have turned on microKEYER II. Router is then configured as required by the
application (logging, control or digital mode) software.
Router must be used to configure microKEYER II for proper operation. The device configuration tabs (in
the red rectangle) are used to setup each part of the microKEYER II.
microHAM © 2008 All rights reserved

Configuring microHAM USB Device Router

microKEYER II
When the USB driver is installed correctly and
microKEYER II is turned on Router will show a device tab
with a GREEN check beside the device name.
When Router shows a YELLOW "X" instead of a green
it means the USB driver is correctly installed but
microKEYER II is not turned on.
When Router shows a RED "X" instead of a green
means the device is disconnected and Router does not see
the USB part of microKEYER II. This happens when the
USB cable is unplugged or the USB driver is not correctly
installed.
Initial Setup
Status
11
,
, it