Address Table Commands
78-21075-01 Command Line Interface Reference Guide
•
interface
ethernet
nonconsecutive Ethernet ports with a comma and no spaces. Use a hyphen
to designate a range of ports.
•
port-channel-list
port-channel
nonconsecutive port-channels with a comma and no spaces; use a hyphen
to designate a range of port channels.
Default Configuration
No forbidden addresses are defined.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
Before defining forbidden ports, the Multicast group should be registered.
You can execute the command before the VLAN is created.
Example
The following example registers a source IP address - Multicast IP address pair to
the bridge table, and forbids adding the pair to port gi9 on VLAN 8:
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)# bridge multicast forbidden source
239.2.2.2 add gi9
29.9
bridge multicast ipv6 mode
Use the bridge multicast ipv6 mode Interface Configuration (VLAN) mode
command to configure the Multicast bridging mode for IPv6 Multicast packets. Use
the no form of this command to return to the default configuration.
Syntax
bridge multicast ipv6 mode
no bridge multicast ipv6 mode
list
-
—Specifies a list of Ethernet ports. Separate
—Specifies a list of port channels. Separate
8
interface vlan
bridge multicast source
{mac-group | ip-group | ip-src-group}
13.16.1.1
group 239.2.2.2
13.16.1.1
group
29
413