Cannot Connect Through Usb; Cannot Display The Home Page - NETGEAR Fuse User Manual

You're connecting to the correct WiFi network (SSID), and you're using the correct WiFi
n
password.
Nobody has changed the name or password of the WiFi network.
n
WiFi is not disabled because your device is tethered. (See Turn WiFi On or Off When Tethered.)
n
Your computer supports the type of WiFi security that the network is set to use.
n
Note: A ll the devices used with the NETGEAR Fuse Mobile Hotspot must support the selected
security type.
Your computer supports WiFi 802.11g (if Connection Rate is set, in the WiFi Options Tab to
n
802.11g only).
Your computer has not been blocked through MAC filtering. (See Manage the Block List (MAC
n
Filtering).)
Tip: I f some settings are preventing you from connecting to WiFi, connect to your device through the
micro-USB cable, and then change the settings. (See Connect with the Micro-USB Cable.)

Cannot Connect Through USB

If your computer cannot connect to the NETGEAR Fuse Mobile Hotspot through the micro-USB
cable, go through the following steps.
Make sure that you've installed the device driver, as described in Making a Tethered Connection.
n

Cannot Display the Home Page

Your Web browser may display an error message when you try to display the home page. The error
message depends on your Web browser.
"Could not connect to remote server" (Opera)
n
"Internet Explorer cannot display the webpage" (Internet Explorer)
n
"Oops! This link appears to be broken" (Google Chrome)
n
"Safari can't open the page" (Safari)
n
"The connection has timed out" (Firefox)
n
Check the following:
Your device is turned on. (See Turn Your Device On and Off.)
n
You have established a connection to your device (through WiFi or through the micro-USB
n
cable).
Make sure you're typing the correct address in the Web browser.
n
Appendix 68