Figure 6-24: Voice - Provisioning Screen - Firmware Upgrade - Linksys SPA9000 User Manual

IP Telephony System
Profile Rule B, C, and D. Enter profile rules B, C, and D.
Log Resync Request Msg. This script defines the message sent to the configured syslog server whenever the
System attempts to resync with the provisioning server. Enter the appropriate script. The default is $PN $MAC --
Requesting resync $SCHEME://$SERVIP:$PORT$PATH.
Log Resync Success Msg. This script defines the message sent to the configured syslog server whenever the
System successfully completes a resync with the provisioning server. Enter the appropriate script. The default is
$PN $MAC -- Successful resync $SCHEME://$SERVIP:$PORT$PATH.
Log Resync Failure Msg. This script defines the message sent to the configured syslog server whenever the
System fails to complete a resync with the provisioning server. Enter the appropriate script. The default is $PN
$MAC -- Resync failed: $ERR.
Report Rule. Enter the report rule.
Firmware Upgrade
Upgrade Enable. The firmware profile must be requested by the System and cannot be pushed from an upgrade
server, although a service provider can effectively push a new firmware load by remotely triggering the request
operation via the configuration file. To enable the upgrade feature, select yes. Otherwise, select no. The default is
yes.
Upgrade Error Retry Delay. If an upgrade attempt fails, the System will retry after a period of time. Enter the
period of time in seconds. The default is 3600.
Downgrade Rev Limit. Enter the downgrade firmware revision limit.
Upgrade Rule. Enter the upgrade rule.
Log Upgrade Request Msg. This script defines the message sent to the configured syslog server whenever the
System attempts an upgrade from the upgrade server. Enter the appropriate script. The default is $PN $MAC --
Requesting upgrade $SCHEME://$SERVIP:$PORT$PATH.
Log Upgrade Success Msg. This script defines the message sent to the configured syslog server whenever the
System successfully completes an upgrade from the upgrade server. Enter the appropriate script. The default is
$PN $MAC -- successful upgrade $SCHEME://$SERVIP:$PORT$PATH -- $ERR.
Log Upgrade Failure Msg. This script defines the message sent to the configured syslog server whenever the
System fails to complete an upgrade from the upgrade server. Enter the appropriate script. The default is $PN
$MAC -- Upgrade failed $ERR.
Chapter 6: Using the Web-based Utility
The Voice Tab
VoIPon Solutions www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0) 1245 600560
Figure 6-24: Voice - Provisioning Screen - Firmware
Upgrade
firmware: the programming code
that runs a networking device.
upgrade: to replace existing software or
firmware with a newer version.
46