Auto-Immune; Wlan Controller Advanced Eap Settings - Cisco 8800 Series Deployment Manual

Auto-Immune

The Auto-Immune feature can optionally be enabled for protection against denial of service (DoS) attacks.
Although when this feature is enabled there can be interruptions introduced with voice over wireless LAN, therefore it is
recommended to disable the Auto-Immune feature on the Cisco Unified Wireless LAN Controller.
To view the Auto-Immune configuration on the Cisco Unified Wireless LAN Controller, telnet or SSH to the controller and
enter the following command.
(Cisco Controller) >show wps summary
Auto-Immune
Auto-Immune....................................
Client Exclusion Policy
Excessive 802.11-association failures.......... Enabled
Excessive 802.11-authentication failures....... Enabled
Excessive 802.1x-authentication................ Enabled
IP-theft....................................... Enabled
Excessive Web authentication failure........... Enabled
Signature Policy
Signature Processing........................... Enabled
To disable the Auto-Immune feature on the Cisco Unified Wireless LAN Controller, telnet or SSH to the controller and enter
the following command.
(Cisco Controller) >config wps auto-immune disable

WLAN Controller Advanced EAP Settings

Need to ensure that the advanced EAP settings in the Cisco Unified Wireless LAN Controller are configured per the
information below.
To view the EAP configuration on the Cisco Unified Wireless LAN Controller, telnet or SSH to the controller and enter the
following command.
(Cisco Controller) >show advanced eap
EAP-Identity-Request Timeout (seconds)........... 30
EAP-Identity-Request Max Retries................. 2
EAP Key-Index for Dynamic WEP.................... 0
EAP Max-Login Ignore Identity Response........... enable
EAP-Request Timeout (seconds)....................
Cisco IP Phone 8800 Series Wireless LAN Deployment Guide
Disabled
30
82