RF Profiles
RF Profiles can be created to specify which frequency bands, data rates, RRM settings, etc. a group of access points should use.
It is highly recommended to enable the SSID used by the Cisco IP Phone 8800 Series to be applied to 5 GHz radios only.
RF Profiles are applied to an AP group once created. See the AP Groups section for more info on AP Group configuration.
When creating an RF Profile, the RF Profile Name and Radio Policy must be defined.
Select 802.11a or 802.11b/g for the Radio Policy.
On the 802.11 tab, configure the data rates as desired.
Is recommended to enable 12 Mbps as Mandatory and 18 Mbps and higher as Supported; however some environments may
require 6 Mbps to be enabled as a mandatory (basic) rate.
Cisco IP Phone 8800 Series Wireless LAN Deployment Guide
73