Abort A Z-Wave Action; Z-Wave Factory Default; Z-Wave Device List - Honeywell TUXWIFIS Installation And Setup Manual

Add a Honeywell Thermostat
1. Install thermostat according to the manufactures instructions. Device should be mounted in the final
location and tested before adding it to the system.
2. Press the Automation
displays a series of messages:
3. On the Honeywell thermostat select Thermostat; set the "Time/Date" and follow the instructions in
the thermostat Installation Guide for "Z-Wave enrollment/inclusion."
4. To complete, press Done.
5. Press Exit to return to normal operation.
6. To verify activation: on Tuxedo, press Back
device is displayed.
NOTE: If not using a Honeywell thermostat, enrollment procedure may vary. Refer to the Thermostat
instructions.
Some thermostats do not update temperature status automatically (i.e., Wayne Dalton).
IMPORTANT: Honeywell is not responsible for property damages due to improper setting of the
thermostat modes.

Abort a Z-Wave Action

If you inadvertently make a wrong selection, (add, delete, or remove failed device) press the Abort
Operation icon to stop the process.
See User Guide to Delete/Edit Z-Wave devices.

Z-Wave Factory Default

Press the Automation
devices from the controller. Follow the on-screen messages and select Yes to confirm.

Z-Wave Device List

To access the list of Z-Wave devices that have been successfully enrolled into the Z-Wave network and
view their status, press the Automation
Z-Wave Setup (cont'd)
, Z-Wave Setup and Z-Wave Add Device
, Z-Wave Setup and Z-Wave Factory Default
icon. Use the OFF or ON buttons to control outputs.
34
; wait 30 seconds. Press Refresh
icons; the screen
; the new
icons to delete all