Device Events; User Codes - Honeywell TUXWIFIS Installation And Setup Manual

Device Events

Tuxedo has the ability to record events in a history log. Each event is recorded with the time and date
of its occurrence.
From the "Home" screen, press the Setup
Press the CS Setup
events is displayed.
To view a record of events in a history log, slide the scroll bar down. The Date, Time and Description of
each event is displayed.

User Codes

Each user must be assigned a name with a corresponding 4-digit user code in order to gain access to
various features and functions. Tuxedo can hold the identity for 10 Users in its memory. If additional
Users are needed, define the additional Users using the Console Emulation Mode.
Users for the system are programmed in a central user setup location that provides the specific
questions for authorization levels assigned to different users. You may want these users to be the same,
but there are situations in which you may want a user to have limited capabilities. These capabilities
are defined by the Authority Level assigned to each user.
Authority Levels
Authority levels define the system functions a particular user can perform. Depending on the authority
assigned to you, there are certain system functions you may be prohibited from performing. The
following information describes the authority levels available in Tuxedo and provides the equivalent
authority level name found in your alarm system manuals. The authority levels available in Tuxedo are
as follows:
Keypad
Authority Functions
Level
Installer Can perform all security functions except can only
disarm if code was used to arm, can change Master
Code, cannot change other user codes, can access the
Central Station Screen options.
Note: This authority level cannot be assigned using
the keypad.
Master Can perform all security functions, add/delete users
in assigned partition, program scheduled events, and
change partition master code.
Normal Perform security functions (arm, disarm)
Guest Can arm the system in assigned partitions, but
cannot disarm the system unless the system was
armed with this code.
Note: Do not assign this level if Quick Arm is enabled
in the system.
No Access Used to restrict access to a partition.
Security (cont'd)
icon and then the System setup
and enter your authorized code. Press the Device Events
Equivalent System Name
Residential
Systems
Installer
Partition
Master
Standard
User
Guest
N/A
30
icon.
icon. A list of
Commercial
Systems
Installer
Level 1
Master
Level 3
Operator A
Level 4
Operator B
N/A