Cisco TelePresence MX200 G2 Administrator's Manual page 61

Cisco TelePresence MX200 G2 and MX300 G2
Contents
Cameras Camera [1] Focus Mode
Set the camera focus mode.
Requires user role: ADMIN
Value space: <Auto/Manual>
Auto: The camera will auto focus once a call is connected, as well as after moving the
camera (pan, tilt, zoom). The system will use auto focus only for a few seconds to set the
right focus; then auto focus is turned off to prevent continuous focus adjustments of the
camera.
Manual: Turn the autofocus off and adjust the camera focus manually.
Cameras Camera 1 Focus Mode: Auto
Example:
Cameras Camera [1] Gamma Mode
This setting enables gamma corrections. Gamma describes the nonlinear relationship between
image pixels and monitor brightness.
Requires user role: ADMIN
Value space: <Auto/Manual>
Auto: Auto is the default and the recommended setting.
Manual: In manual mode the gamma value is changed with the gamma level setting, ref:
Cameras Camera [1..n] Gamma Level.
Cameras Camera 1 Gamma Mode: Auto
Example:
Cameras Camera [1] Gamma Level
By setting the Gamma Level you can select which gamma correction table to use. This setting
may be useful in difficult lighting conditions, where changes to the brightness setting does not
provide satisfactory results. Requires the Gamma Mode to be set to Manual.
Requires user role: ADMIN
Value space: <0..7>
Range: Select a value from 0 to 7.
Cameras Camera 1 Gamma Level: 0
Example:
D15078.04 MX200 G2 and MX300 G2 Administrator Guide TC7.3, DECEMBER 2014.
Introduction Web interface System settings System settings
Cameras Camera [1] Mirror
With Mirror mode (horizontal flip) you can mirror the image on screen.
Requires user role: ADMIN
Value space: <Off/On>
Off: See the self-view in normal mode, that is the experience of self-view is as seeing
yourself as other people see you.
On: See the self-view in mirror mode, that is the self-view is reversed and the experience of
self-view is as seeing yourself in a mirror.
Cameras Camera 1 Mirror: Auto
Example:
Cameras Camera [1] Whitebalance Mode
Set the camera white balance mode.
Requires user role: ADMIN
Value space: <Auto/Manual>
Auto: The camera will continuously adjust the white balance depending on the camera view.
Manual: Enables manual control of the camera white balance. The white balance level is set
using the Cameras Camera Whitebalance Level setting.
Cameras Camera 1 Whitebalance Mode: Auto
Example:
Cameras Camera [1] Whitebalance Level
Set the white balance level. Requires the Camera Whitebalance Mode to be set to manual.
Requires user role: ADMIN
Value space: <1..16>
Range: Select a value from 1 to 16.
Cameras Camera 1 Whitebalance Level: 1
Example:
www.cisco.com — Copyright © 2013–2014 Cisco Systems, Inc. All rights reserved.
61
Administrator Guide
Setting passwords Appendices