Cisco TelePresence MX200 G2 Administrator's Manual page 47

Cisco TelePresence MX200 G2 and MX300 G2
Contents
Capturing user interface
screenshots
You can capture screenshots both of a Touch controller that is
connected to the video system, and of the on-screen display
(menus, indicators and messages on the main display).
D15078.04 MX200 G2 and MX300 G2 Administrator Guide TC7.3, DECEMBER 2014.
Introduction Web interface Web interface
Navigate to: Diagnostics > User Interface Screenshots
Capture a screenshot
Click Take screenshot of Touch Panel
capture a screenshot of the Touch controller,
or click Take screenshot of OSD
screenshot of the on-screen display.
The screenshot will display in the area below
the buttons. Note that it can take up to
30 seconds before the screenshot is ready.
All captured snapshots are included in the list
above the buttons. Click the screenshot ID to
display the image.
System settings
to
to capture a
www.cisco.com — Copyright © 2013–2014 Cisco Systems, Inc. All rights reserved.
47
Administrator Guide
Setting passwords Appendices
Deleting screenshots
If you want to delete all screenshots,
click Remove all.
To delete just one screenshot, click
×
the button for that screenshot.