Controlling The Far End Camera - Cisco TelePresence MX200 G2 Administrator's Manual

Cisco TelePresence MX200 G2 and MX300 G2
Contents

Controlling the far end camera

While in a call, you can control the remote participant's
camera (far end) provided that:
• The Conference FarEndControl Mode
On on the far end video system.
• The far end camera has pan, tilt or zoom functionality.
Only the relevant controls will appear.
D15078.04 MX200 G2 and MX300 G2 Administrator Guide TC7.3, DECEMBER 2014.
Introduction Web interface Web interface
Navigate to: Call Control
setting is switched
Control the remote participant's camera
1. Click the camera icon to open the remote camera
control window.
2. Place the cursor in the image to enable the controls.
If you are not allowed to control the far end camera,
the controls will not appear when you place the
cursor in the image.
3. Use the left and right arrows to pan the camera; the
up and down arrows to tilt it; and
and out.
System settings
+ and - to zoom in
www.cisco.com — Copyright © 2013–2014 Cisco Systems, Inc. All rights reserved.
22
Administrator Guide
Setting passwords Appendices