About Snapshots - Cisco TelePresence MX200 G2 Administrator's Manual

Cisco TelePresence MX200 G2 and MX300 G2
Contents

About snapshots

The snapshot feature allows snapshots of the video system's
input sources to be displayed on the Call Control page. This
applies both when the system is idle and in a call. In a call,
snapshots of the far end system may be displayed as well.
This feature might come in handy when administering the
video system from a remote location, e.g. to check the
camera view and control the camera.
The video system's users will be notified when the
snapshot feature is in use. A notification saying that
the administrator is visually monitoring the room is
displayed on the video system's main display.
Enabling the snapshot feature
By default, the snapshot feature is disabled for devices that
are not physically connected to the video system (including
the web interface).
Enable the feature using the web interface.
• Go to the Configuration tab and select
Configuration
• Navigate to Video > AllowWebSnapshots
• Click Save for the change to take effect.
About far end snapshots
As long as the Video AllowWebSnapshots
On on the local video system, far end snapshots may be
captured even if snapshots are disallowed on the far end
video system. Snapshots are prohibited only for encrypted
calls.
You can also prohibit snapshots from being taken by
switching the Conference FarEndControl Mode
the far end video system.
D15078.04 MX200 G2 and MX300 G2 Administrator Guide TC7.3, DECEMBER 2014.
Introduction Web interface Web interface
Navigate to: Call Control
System
and choose On.
setting is switched
setting Off on
System settings
View snapshots from the input sources
Click in this area to view snapshots from the
selected main source or presentation source.
Snapshots of the main or presentation source will
be displayed for approximately 10 seconds. .
16
Setting passwords
Snapshots are captured during both local
and remote camera control. Camera control
is enabled by clicking the camera icon.
www.cisco.com — Copyright © 2013–2014 Cisco Systems, Inc. All rights reserved.
Administrator Guide
Appendices
Camera control