Netpit And Pit Devices; Figure 5-7 Cash Registers Connected To A Honeywell Pit - Honeywell Rapid Eye Hybrid LT Installation Manual

Site Hardware

NetPIT and PIT Devices

OT
TOR
1 2 3 4 5
VIDEO
INPUTS
TELCO
SERIAL PORT 2
SERIAL PORT 1 VGA
USB
64
To connect a Rapid Eye Hybrid LT DVR to a point-of-sale (POS) device—a cash register,
automatic teller machine (ATM), and so on—a device is needed for Protocol Interface
Translation (PIT) or Network Protocol Interface Translation (NetPIT). Rapid Eye Hybrid LT
DVRs support PITs and a NetPIT, for attaching many serial devices to a DVR.
A PIT can provide communications for one device (AVBPIT1) or up to four devices
(AVBPIT4POS). A NetPIT device provides communications for up to 16 POS devices from
one serial port.
Figure 5-7 Cash Registers Connected to a Honeywell PIT
COMMON
CONTROL
SYS FAIL
OUTPUTS
SYS GOOD
1 G 2 G 3 G 4 G
FAULT
RELAY
6 7 8 28V, 3A
MAX
1 G 2 G 3 G 4 G 5 G 6 G 7 G 8
ALARM INPUTS
LAN
IN
OUT
115-230V~
50/60 Hz
NOT
5-3A
USED
USB
PIT and NetPIT devices are connected to the serial ports on the back of Rapid Eye Hybrid
LT DVRs. Your installer configures the PIT/NetPIT device for use with the make and model
of POS device. NetPIT supports applications by Retalix® (RetPIT), Micros® (MicPIT) and
AtmPIT.
Port Restrictions
Only one NetPIT device can be supported; only one can be assigned to a Rapid Eye Hybrid
LT port. Up to 16 POS devices can be assigned to a NetPIT device.
Note A PIT device cannot be assigned to a NetPIT port.
Assignment Limits
Up to four PIT serial devices can be supported. Four POS devices can be assigned to each
PIT device.
Configuring POS, PIT and NetPIT Devices for Rapid Eye
For procedures to configure POS devices, using the Serial Devices tab in the Maintenance
dialog, refer to the Rapid Eye™ Hybrid HD and Hybrid LT Digital Video Recorders System
Administrator Guide.
PIT/NetPIT
SERIAL
PORT 3
SERIAL
PORT 4
G
ON/OFF
POWER
Up to 16 POS devices
per serial port