Table of Contents
Advertisement
Site Hardware
Configuring PTZ
Driver (name)
Bossware
Honeywell fixed camera 9600
Intellibus
Javelin 308
Kalatel
Pelco D
Pelco P
Rapid Dome/Orbiter
SensorMatic RS422
Ultrak (using VCL)
Ultrak KD6
a
The drivers are not listed alphabetically in the View application. A driver can be used with
domes other than those listed. For other domes, controllers, or PIT devices, refer to the docu-
mentation provided with the device.
b
Intellibus protocol will be supported in a future release.
58
Consistent Port Attributes
Honeywell recommends that if domes are to share a serial communications line, installers
should select domes that:
•
Function at the same settings for: Baud Rate, Data Bits, Parity, and Stop Bits.
•
Use the same PTZ drivers.
Caution
Domes that require different PTZ drivers may not function as expected if
they are installed on the same port/serial communications line.
Use the View application to run a maintenance session. Use the Video tab to configure PTZ
settings. Hybrid LT DVRs support the PTZ domes listed in
support many types of PTZ software drivers at the same time. Refer to the
Hybrid HD and Hybrid LT Digital Video Recorders System Administrator
procedures to enable a PTZ dome.
Table 5-3
PTZ Drivers for Controllers and Domes
a
Baud rate
19200
b
38400
9600
9600 or 2400
4800, 9600, or 2400 Pelco D
2400
9600
4800
2400
9600
Caution
After the installation, installers should communicate to the System
Administrator: each address used by the PTZ domes and the number of
the port used for PTZ on the Rapid Eye Hybrid LT DVR.
Table
5-3. A Hybrid LT site can
Support for (dome/controller/PIT device)
PIT device, to which domes are connected
Honeywell HCU484
ACUIX camera
Javelin 308 Controller
Kalatel KTD312 Cyberdome
Pelco P
RapidDome or Orbiter
SensorMatic RS422: Delta and Speed
Ultrak (configured as VCL)
KD6, HD6, HD6i
Rapid Eye™
Guide, for
Advertisement
Table of Contents
