Makita LS1212 Instruction Manual page 21

In
the case of right bevel cut
Bevel angle
52/38"
type
45" type
Poiition
in tiq ( C I
Table (A)
Miter angle
52138" type 45" type
1 F o r inside corner
-
- 1
Right 33 9 "
1-01
outside corner
Right 31 6" Right 35 3"
Right 30"
Right 31
6 O
Right 35 3 "
1
Molding edge against guide fence
1
Finished piece
position
iri Fig ( C i
For inside corner
-
Wall contact edge should be
against guide fence
Finished piece will be on the
Right side of blade
0
0
Ceiling contact edge should
be
against guide fence
Finished piece will be on the
Left side of blade
tor outside Lorner
1
Wall contact edae should be
I
cb
1
against guide fe&e
(Example)
In the case of cutting 52/38' type crown molding for position
0)
in Fig. (C):
*Tilt and secure bevel angle setting to 33.9' RIGHT.
*Adjust and secure miter angle setting to 31.6" RIGHT.
*Lay crown molding with its broad back surface down on the turn base with its WALL
CONTACT EDGE against the guide fence on the saw.
*The finished piece to be used will always be on the RIGHT side of the blade after the
cut has been made.
21