Makita LS1212 Instruction Manual page 13

Sub-fence R (optional accessory)
The subfence
R
can be installed on the
right side of the guide fence. Insert the
rods of the sub-fence
R
into the holes in
the guide fence. Tighten the screws which
come with the sub-fence
R
to secure the
sub-fence R.
CAUTION:
When performing right bevel cuts, never
use the sub-fence R. It will contact the
blade or some part of the tool, causing in
serious injury to operator.
Subfence R
Screws
Vertical vise
The vertical vise can be installed in two positions on either the left or right side of the
guide fence, or the holder assembly (optional accessory).Insert the vise rod into the hole
in the guide fence or the holder assembly and tighten the screw to secure the vise rod
(Note: When using the holder assembly, install it on the holder as shown in Fig.)
Position the vise arm according to the thickness and shape of the workpiece and secure
the vise arm by tightening the screw. If the screw to secure the vise arm contacts the
guide fence, install the screw on the opposite side of vise arm.
Make sure that no part of the tool contacts the vise when lowering the handle fully or
when pulling or pushing the carriage. If some part contacts the vise, re-position the vise.
Press the workpiece flat against the guide fence and the turn base. Position the work-
piece
a t
the desired cutting position and secure it firmly by tightening the clamp screw of
the vise. The maximum thickness of workpieces which can be secured by the vertical vise
is 120 mm (4-3/4")
Screw
13