Makita LS1212 Instruction Manual page 15

Holders and holder assembly (optional accessories)
The holders and the holder assembly can be installed on either side as
a
convenient
means
of
supporting workpieces horizontally. Install them as shown in Fig. Then tighten
the screws firmly to secure the holders and the holder assembly.
Screws
Holder
When cutting long workpieces, use the holder-rod assembly (optional accessory). It con-
sists of two holder assemblies and two rods 12.
Holder assembly
CAUTION:
Always support long workpieces level with the top surface of the turn base for accurate
cuts and to prevent dangerous loss of control of the tool.
15