Makita LS1212 Instruction Manual page 20

When cutting crown and cove moldings, set the bevel angle and miter angle as indi-
cated in the table
(A)
and position the moldings on the top surface of the saw base as
indicated in the table (B).
Bevel angle
In
the
case
of left bevel
cut
Miter angle
Table IAl
Right 31 6 " Right 35 3 "
tor inside corner
tor outside corner
M o l d i n g
position
in tiq IC)
I
Right 31 6'
I
Right 35 3 "
Molding edge against guide fence
Finished piece
Left 30° Left 31 6 " Left 35 3'
For
inside corner
0
0
For
outside corner
@
Ceiling contact edge should be
against quide fence
Firiished piece will be on the
Left side of blade
Wall contact edge, should be
sgainbt guide f e n w
Finished piece will be on the
Right
'Ide
Of
blade
Ceiling contact edge should be
against guide fence
(Example)
In the case of cutting 52/38" type crown molding for position
@
in Fig.
(C):
*Tilt and secure bevel angle setting to 33.9" LEFT.
*Adjust and secure miter angle setting to 31.6' RIGHT.
*Lay crown molding with its broad back surface down on the turn base with its CEIL-
*The finished piece to be used will always be on the LEFT side of the blade after the
ING CONTACT EDGE against the guide fence on the saw.
cut has been made.
20