Boot Dialog For Icim/Snmp Configuration - Cisco Prisma II Installation And Operation Manual

Boot Dialog for ICIM/SNMP Configuration

The boot dialog is presented whenever the ICIM is powered up (a cold boot). It is
accessible via the LCI communications port on the front of the chassis.
Important: A null modem is required along with a terminal emulator program, such
as HyperTerminal on a Windows PC.
The serial port on the PC used by the terminal emulator program should be set up
with these parameters:
9600 baud

8 data bit

No parity bit

1 stop bit

This parameter is often displayed as: 9600 8-N-1
The boot dialog's primary use is to flash a new version of the ICIM application via a
TFTP server.
Important: Do this only under the direction of Cisco Services.
78-4015908-01 Rev F

Boot Dialog for ICIM/SNMP Configuration

71