Module Configuration; Configuration And Monitoring Methods - Cisco Prisma II Installation And Operation Manual

Chapter 1 Module Introduction

Module Configuration

The module is shipped from the factory with operational parameters set to factory
defaults. However, you will probably choose to configure the operating parameters
so that they are best suited for your application.

Configuration and Monitoring Methods

The module may be controlled and monitored using any of the following methods.
Prisma II ICIM Front Panel

When a standard Intelligent Communications Interface Module 2 (ICIM2) is
used, its front-panel LCD and keypad interface can be used to configure and
monitor this and other Prisma II modules in the ICIM domain. For instructions
on operating this module using this ICIM, refer to Operation using ICIM (on
page 39).
LCI Software

Local Craft Interface (LCI) software running on a locally connected PC may be
used to configure operating parameters of Prisma II modules. For instructions on
operating this module using LCI software, refer to Operation using LCI (on page
75).
TNCS Software

If an ICIM2 or ICIM2-XD is installed, TNCS software may be used to configure
and monitor all Prisma II modules in the ICIM domain. For instructions on
operating this module using TNCS, refer to the TNCS Administrator Release 3.0
Software User's Guide, part number 4013494.
CLI Commands

If an ICIM2 or ICIM2-XD is installed, command line interface (CLI) commands
enable communication between the ICIM and the operator over Telnet to allow
for remote module setup and monitoring. For details, see the Prisma II Platform
Remote User Interface Guide, System Release 2.03, part number 4025477.
ICIM Web Interface

The ICIM Web Interface offers a user-friendly alternative to CLI commands for
remote module setup and monitoring using an ICIM2 or ICIM2-XD. Users
navigate a series of HTML pages through a standard web browser to view and,
where permitted, adjust module parameters. For additional information, see the
Prisma II Platform Remote User Interface Guide, System Release 2.03, part number
4025477.
10 78-4015908-01 Rev F