Cisco Prisma II Installation And Operation Manual page 44

Chapter 2 Module Installation
4 Connect RF cables to the Port B and Port D connectors for the chassis slot in
which the module will be installed. These are the RF output connections for the
module in the upper half-slot position. Hand-tighten the connectors.
5 Route the RF cables from Ports B and D (for the upper half-slot module) to the
appropriate RF destinations.
6 If F connectors are installed, use a 7/16-in. open-end wrench to secure all cables
to the connectors at the chassis.
Prisma II XD Chassis
Attach a 75-ohm RF cable to the appropriate RF destination.
1
2 Locate the RF ports at the back of the chassis.
Attach the other end of the RF cable to Port A connector of the corresponding
3
slot where the module is to be installed. This is the RF output connection.
If F connectors are installed, use a 7/16-in. open-end wrench to secure all cables
4
to the connectors at the chassis.
20 78-4015908-01 Rev F