Cisco Prisma II Installation And Operation Manual page 145

Redundancy Interface Panel • 35
RF • 117
RMA • 117
RT • 117
RX • 117
S
Saving the Configuration using the ICIM • 63
SBS • 117
Setting SNMP Trap Receiver Parameters • 68
Site Requirements • 15
SMC • 118
SNMP • 118
SNMP Configuration • 64
SNMP Considerations • 64
Space Requirements • 16
Starting LCI Software • 83
STATUS Menus • 56
System Requirements • 77
T
Table of Inserted Modules • 69
Table of Removed Modules • 69
TEC • 118
Tips for Optimal Fiber Optic Connector
Performance • 26
TNCS • 118
To Access the ICIM LCD Contrast • 51
To Access the Module Details, Double-Click the
Chassis • 88
To Access the Module Details, Double-Click the
Module • 90
To Access the Module Details, Right-Click the
Chassis • 89
To Access the Module Details, Right-Click the
Module • 91
To Access the Password Menu • 47, 48
To Adjust Alarm Thresholds • 74
To Change Parameters • 73
To Change the User Password • 48
To Check Alarms using ICIM • 59
To Check Alarms using LCI • 95
To Check Manufacturing Data • 61
To Check Manufacturing Data using LCI • 99
To Check Operating Status using LCI • 92
To Check the Operating Status using ICIM • 55
To Clean Optical Connectors • 27
To Configure Parameters using LCI • 93
To Configure Parameters using the ICIM • 57
To Connect a Computer to the Chassis • 81
78-4015908-01 Rev F
To Connect Chassis-to-Chassis ICIM IN and
ICIM OUT Ports • 30
To Connect Optical Cables to Module • 28
To Connect RF Cables for Each Module • 19
To Connect TNCS to the Chassis EM IN Port •
31
To Disable the User Password using ICIM • 49
To Enter the User Password • 46, 47
To Install the LCI Software • 78
To Install the Module in a Prisma II XD Chassis
• 23
To Install the Module in the Chassis • 22
To Install the Receiver Modules in the Host
Module • 21
To Modify Alarm Limits using LCI • 97
To Prepare to Change Parameters • 72
To Pull the Optical Cable to the Module • 25
To Restart the ICIM by Removing the ICIM • 66
To Restart the ICIM using ICIM • 73
To Save the Current Configuration • 63
To Set Adjustable Alarm Thresholds using the
ICIM • 60
To Set Traps for a Specific IP Address using
P2TrapRecvEntry • 68
To Set Up the IP Configuration Parameters for
SNMP Support using ICIM • 64
To Start LCI Software • 83
torque • 118
Troubleshooting • 103
Troubleshooting Alarm Conditions • 103, 104
TX • 118
U
Unpacking and Inspecting the Module • 14
Using the ICIM • 51
Using TNCS with Multiple Chassis • 32
Index
121