Obihai OBi110 Administration Manual page 137

DialDelay
DialDigitOnTime
DialDigitOffTime
DirectoryNumber
Calling Features
CallForwardUnconditionalEnable
CallForwardUnconditionalNumber
CallForwardOnBusyEnable
- Detect polarity reversal: Device will detect
a polarity reversal signal on the line as a
positive indication of call connected state.
Note that polarity reversal signal is not always
generated by the phone company when a call is
answered. However, if available, polarity reversal
is the most robust signal for detection of call
connected state.
If the method is not "None", the device will also
indicate peer ringing state when it detects ring
back signal on the line prior to call connected
state.
Delay in milliseconds before dialing out the first
digit to the PSTN line after the OBi takes the LINE
port hardware to the Off-Hook state. This is a
simple way to allow the PSTN company time to get
ready to receive DTMF signals from the OBi
without having the OBi monitor dial tone from the
PSTN company
Duration in milliseconds of each digit to dial out on
the PSTN line
Interdigit time in milliseconds when dialing a
number on the PSTN line
Phone number of the attached PSTN line.
Informational only; not used by OBi device
Enable call forwarding of all calls unconditionally
by the device. If CallForwardUnconditionalNumber
is blank, this parameter is treated as if it has been
set to No.
Note: It is possible for a user to set this parameter
from the phone using a Star Code
Directory number to forward all incoming calls on
this service unconditionally. Maximum Length is
127 characters.
Note: It is possible for a user to set this parameter
from the phone using a Star Code
Enable call forwarding of all incoming calls when
the device is busy. If CallForwardOnBusyNumber is
blank, this parameter is treated as if it has been set
to No. Device is considered busy if one of the
following conditions holds:
DND (Do Not Disturb) Service is enabled on this
service
If the call is routed to the PHONE port when the it
is in a busy state (such as ringing, dialing, playing
reorder tone, or already having 2 calls in progress)
Note: It is possible for a user to set this parameter
from the phone using a Star Code
Copyright 2010-2012 Obihai Technology, Inc.
500
200
200
No
No
137