Obihai OBi110 Administration Manual page 108

CallOnHoldRing
RepeatDialRing
DTMFMethod
UseFixedDurationRFC2833DTMF
OBiTALK Calling Features Parameter Guide:
Parameter
CallForwardUnconditionalEnable
CallForwardUnconditionalNumber
CallForwardOnBusyEnable
PHONE port according to the InboundCallRoute of this
service. The ring pattern is taken from the selected Ring
Profile. Valid choices are 1-10
Pattern to ring PHONE port when holding a call on this
trunk that has been connected to the PHONE port.
Typically this is a very short distinctive ring pattern that
serves as a reminder to the user that a call is being on
hold. The ring pattern is taken from the selected Ring
Profile. Valid choices are: NO Ring, or 1-10
The ring pattern number to use to ring the PHONE port
when a repeat dial operation on this trunk is successful
as the called party is either ringing or answered
Method to pass DTMF digits to peer device. Available
choices are:
Inband - DTMF tone are sent as inband audio signal
RFC2833 - DTMF tone events are relayed per RFC2833
SIPInfo - DTMF tones are relayed with SIP INFO request
Auto - Method to use based on call setup negotiation
(either Inband or RFC2833 may be negotiated)
When relaying DTMF digit events on this trunk using
RFC2833, the RFC2833 RTP packets normally will keep
streaming for as long as the digit is pressed. With this
option set to TRUE, the device sends only one RTP digit
event packet with a fixed duration of 150 ms regardless
how long the digit has been pressed
Description
Enable call forwarding of all calls unconditionally by the
device. If CallForwardUnconditionalNumber is blank, this
parameter is treated as if it has been set to No.
Note: It is possible for a user to set this parameter from
the phone using a Star Code
Directory number to forward all incoming calls on this
service unconditionally. Maximum Length is 127
characters.
Note: It is possible for a user to set this parameter from
the phone using a Star Code
Enable call forwarding of all incoming calls when the
device is busy. If CallForwardOnBusyNumber is blank,
this parameter is treated as if it has been set to No.
Device is considered busy if one of the following
conditions holds:
This service already reaches the limit of simultaneous
calls as specified in MaxSessions
DND (Do Not Disturb) Service is enabled on this service
If the call is routed to the PHONE port where the phone
is in a busy state (such as ringing, dialing, playing
reorder, or already having 2 calls in progress)
Note: It is possible for a user to set this parameter from
Copyright 2010-2012 Obihai Technology, Inc.
8
4
AUTO
FALSE
Default Setting
No
No
108