Obihai OBi110 Administration Manual page 132

ConferenceCallEnable
CallWaitingEnable
ToneProfile
StarCodeProfile
LastDialedNumber
LastCallerNumber
AcceptMediaLoopback
MediaLoopbackAnswerDelay
MediaLoopbackMaxDuration
RepeatDialInterval
by the user by hanging up the phone in one of the
following scenarios:
- One call on hold while a 2
- One call on hold while a 2
- One call connected while a 2
- 3-way conference with both calls connected
If Call Transfer is disabled, hanging up the phone in the
above scenarios simply ends all the calls, except for the
one that is holding, which will remain on hold (cases 1
and 2).
Enable 3-way Conference Call w/ local audio mixing.
Conference Call, if enabled, is initiated by the user by
hook flashing the phone in one of the following scenarios:
- One call on hold while a 2
- One call on hold while a 2
We refer to case (1) as an early conference, where the
second conferencee is still ringing; the other 2 parties
may converse while hearing ringback tone in the
background until the 3 party answers. In either case, the
user can end the call with the second conferencee by
hook flashing another time and the call reverts to a 2-way
call.
If Conference Call service is disabled, then hook flashing
the phone resumes the holding call but ends the second
outgoing call in scenario (1), and swaps between the two
calls in scenario (2) (as in a call waiting situation)
Enable call waiting service. Call Waiting is the situation
where a new incoming call is routed to the PHONE port
when there is already another call connected. If this
service is enabled, OBi plays call-waiting tone to alert the
user, as well as generates CWCID signal if CWCID is
enabled. The user may then swap between the two calls
by hook flashing. If the service is disabled, OBi rejects the
incoming call as busy.
Note: It is possible for the user to set this parameter from
the phone using a Star Code
Select a Tone Profile for call progress tone generation.
Choices are A, or B
Select a Star Code Profile for interpreting Star Codes
entered by the user. Choices are None, A, or B. If value is
set to None, no star code will be recognized by OBi
device.
Last number dialed out on the PHONE port
Last caller's number that rings the PHONE port
Enable the device to accept incoming media loopback
calls
Delay in milliseconds before the device answers an
incoming media loopback call
Maximum duration in seconds to allow for an inbound
media loopback call. Set the value to blank or 0 to make it
unlimited
Interval in seconds between redial in a repeat dial
Copyright 2010-2012 Obihai Technology, Inc.
nd
outgoing call ringing
nd
outgoing call connected
nd
outgoing call ringing
nd
outgoing call ringing
nd
outgoing call connected
Yes
Yes
A
A
Yes
0
0
30
132