Obihai OBi110 Administration Manual page 116

OutboundCallRoute After the caller dials a number that is acceptable by
the AA (according to its DigitMap) to make a further
call, the device uses this outbound call routing rule
to determine which service to make this call with.
See OBi Call Routing and Digit Map Section for a
description of the syntaxes to specify this
parameter
Note that while forking to multiple numbers in an
AA outbound call routing rule is not supported on
OBi100 and OBi110, it is supported on the OBi202.
For example, on the OBi202 you may have a rule
like this: {0:ph,ph2} which forks to ring both
PHONE1 and PHONE2. In general you can have up
to 4 destinations is a forking rule. On the other
hand, you must not specify more than one
destination number on the OBi100 and OBi110.
PrimaryLine By primary line we mean the service that does not
require any access code prefix (such as **1 or **9)
when dialing; it is the default service to be used for
making the call when no explicit access code prefix
is entered. This parameter indicates to the device
which voice service is considered as the primary line
when dialing out via the Auto Attendant. Available
choices are:
SP1 Service (code = sp1)
SP2 Service (code = sp2)
SP3 Service (code = sp3)
SP4 Service (code = sp4)
OBiTALK Service (code = pp1)
PSTN Line (code=li1)
Trunk Group 1 (code=tg1)
The OBi device process the parameter by
substituting of the occurrences of pli and (Mpli) in
DigitMap and OutboundCallRoute with the
corresponding code and (Mcode). For example, if
PrimaryLine = PSTN Line, then all occurrences of pli
and (Mpli) will be substituted internally with li1 and
(Mli1) respectively
AnswerDelay Period of time in milliseconds that the AA will wait
before answering an incoming call that has been
routed to it
NumberOnNoInput In the case that the caller does not enter any option
from the top level menu after the menu has been
1
Copyright 2010-2012 Obihai Technology, Inc.
For OBi100:
{([1-9]x?*(Mpli)):pp},
{0:ph},
{(<**1:>(Msp1)):sp1},
{(<**2:>(Msp2)):sp2},
{(<**9:>(Mpp)):pp},
{(Mpli):pli}
For OBi110:
{([1-9]x?*(Mpli)):pp},
{0:ph},
{(<**1:>(Msp1)):sp1},
{(<**2:>(Msp2)):sp2},
{(<**8:>(Mli)):li},
{(<**9:>(Mpp)):pp},
{(Mpli):pli}
For OBi202:
{([1-9]x?*(Mpli)):pp},
{0:ph.ph2},
{(<**1:>(Msp1)):sp1},
{(<**2:>(Msp2)):sp2},
{(<**3:>(Msp3)):sp3},
{(<**4:>(Msp4)):sp4},
{(<**9:>(Mpp)):pp},
{(Mpli):pli}
PSTN Line
4000
0
116