Obihai OBi110 Administration Manual page 130

Voice service bridge and terminal adapter; telephone adapter and voice service bridge; voip phone adapter with router, 2-phone ports, t.38 fax; voip phone adapter with router, 2-phone ports, t.38 fax (sip only)
Table of Contents

Advertisement

DTMFPlaybackLevel
CallerIDMethod
CallerIDTrigger
ChannelTxGain
ChannelRxGain
SilenceDetectSensitivity
Calling Features
CallCommandSignalMethod
HookFlashHandling
-
600+1 uF
-
220+(820||115 nF)
Out of band DTMF tone playback level in dBm (-90 to 3)
Caller ID delivery standard. Choices are:
FSK(Bell202)
FSK(V.23)
DTMF(Finland,Sweden)
DTMF(Denmark)
Triggering event for on-hook Caller ID signal generation.
Choices are:
After First Ring
After Polarity Reversal
Before First Ring
Transmit gain in dB (-12 to 12) to apply to signal sent from
OBi to the attached phone(s)
Receive gain in dB (-12 to 12) to apply to signal received
by OBi from the attached phone(s)
PHONE port silence detection servers the purpose of
driving silence suppression in RTP transmission when the
phone Call terminates on SP1/2 or OBiTALK Service and
silence suppression is enabled.
This parameter is used to set a sensitivity level for OBi
silence detection algorithm. Available choices are:
Low (harder to detect silence)
Medium (suggested)
High (easier to detect silence)
Select the method to signal a command to the OBi when
the phone is off-hook with an active call in connected
state, while there is a second call on hold or ringing. The
two choices are:
- N. America (uses hook switch events only)
- Nordic Regions (R1, R2, ...),
where R = hook flash or the 'R' button,
R0 = Reject the 2nd incoming call (applicable only if the
nd
2
call is ringing),
R1 = End current call, resume/answer the 2
R2 = Hold current call, resume/answer the 2
R3 = Conference the two calls
nd
R4 = Transfer 2
call peer to the 1
call is ringing)
Indicate the Method to Handle Hook Flash. Choices are
Handle Hook Flash Locally
This is the normal setting, where the device intercepts all
the hook flash events detected on the PHONE port, and
acts on them accordingly, such as:
- Hold current call and start second dial tone for 3-way
calls
- Start a 3-way conference
nd
- End call with 2
conferencee in a 3-way conference
- Swap between two calls in a call-waiting situation
Copyright 2010-2012 Obihai Technology, Inc.
nd
call
nd
call
st
nd
(not applicable if 2
-15
FSK(Bell202)
After First Ring
0
0
Medium
N. America
Handle Hook Flash Locally
130

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Obi100Obi202Obi302

Table of Contents