Table of Contents
Advertisement
Pocket AL I/O
2. INSTALLATION
The installation of Pocket AL I/O is extremely easy and fast. The configuration can be performed locally through a terminal emulator
or remotely through a common GSM phone and SMS messages.
2.1. HArdwAre InstALLAtIOn
Before going on with the configuration, it is necessary to complete the hardware installation of Pocket AL I/O. Connect the sensors
to the input contacts of Pocket AL I/O and then connect the eventual devices to be remote piloted to the output pins. When Pocket
AL I/O receives the configuration messages, it will store the current situation of that input as "non alarmed" status, whether it is
OPEN or CLOSED.
2.1.1. starting procedure
• Connect Pocket AL I/O to a computer COM port. The device in factory configuration accepts commands at 115200 bps only.
This operation is not necessary in case you configure the device via SMS.
• Connect the inputs and outputs to be managed. See the next paragraphs for the pins of terminal boards.
• Connect the GSM antenna.
• Insert the SIM card into Pocket AL I/O.
• Power on Pocket AL I/O. See the next paragraph for the 6 PINs terminal board.
2.1.2. 6 PIn terminal board description
Front view
2.1.3. 20 PIn terminal board description
Front view
The wires must be stripped for about 10 mm
so you can insert them correctly in the female clips
NOTE:
Open Collector: max 60Vcc - 700mA
Relay output: max 60Vcc - 1A
PIN
LABEL
PWR
1
+
2
-
4-20mA
3
+
4
S
5
+
6
S
IN
O.C.
OPT
RL1
RL2
Optoinsulated input: from 5Vcc to 32Vcc
Installation
DESCRIPTION
Power from +5 to +32 Vcc
GND ground
Power per sensor Out +12Vcc
Analog input 1
Power per sensor Out +12Vcc
Analog input 2
PIN
DESCRIPTION
1
GND ground
2
Non optoinsulated input 1
3
Non optoinsulated input 2
4
Non optoinsulated input 3
5
Non optoinsulated input 4
6
GND ground
7
Open Collector output 1
8
Open Collector output 2
9
Open Collector output 3
10
Open Collector output 4
11
Optoinsulated input 1
12
Optoinsulated input 1
13
Optoinsulated input 2
14
Optoinsulated input 2
15
Relay output 1 N.A.
16
Relay output 1 C
17
Relay output 1 N.C.
18
Relay output 2 N.A.
19
Relay output 2 C
20
Relay output N.C.
2.1
Advertisement
Table of Contents
