Table of Contents
Advertisement
Pocket AL I/O
Example of alarm messages of contact 15
HOME
15)MainPower ON
BATTERY: CHARGING
HOME
15)MainPower OFF
BATTERY: LOW
3.8. STANDBY mANAGEmENT
Pocket AL I/O is always active but it may be necessary to interrupt its operation temporarily and put it in STANDBY status without
powering it off.
For particular needs you can also leave Pocket AL I/O always in Standby status. In this way, as you will not be automatically informed,
you can verify the inputs status by remote querying Pocket AL I/O with the #TEST# message described in the next paragraph.
Pocket AL I/O can be remote enabled or disabled through a proper configuration message.
In STANDBY status Pocket AL I/O will not send automatically any message so no Status/Transition change will be signalled as
well as the main power off.
Just after the remote activation, Pocket AL I/O will send a confirmation message to the user that requested the status change
specifying the current device status.
3.8.1. Standby configuration message
The message format to set the STANDBY function is the following:
# STANDBY #
User 1
NAME
VALUE
STANDBY
STANDBY
User n
+ 0..9
NOTES
1. If you want to add a phone number to the already set list, it will be necessary to insert all the numbers
again.
2. The users' phone number can include or not the international prefix precedeed by + character (i.e.
+393351122334).
3. 0 (zero) character inserted in User 1 will cancel the whole list.
4. If User field is empty, anyone will be able to manage the standby
Examples
#STANDBY#+393359988776#
#STANDBY#0#
3.8.2. Standby enabled/disabled message
The enabling/disabling of Pocket AL I/O can be controlled only by authorized users whose phone numbers are inserted during
the STANDBY status configuration.
#ENABLE#
It enables Pocket AL I/O operative status (STANDBY disabled)
#DISABLE#
It disables Pocket AL I/O (STANDBY enabled)
NOTE
1. The words ENABLE and DISABLE are accepted both in upper and lower case.
#
User 2
#
User 3
DESCRIPTION
Key used for the standby configuration: STANDBY
Phone numbers of the users enabled to manage the standby (up to six phone numbers can
be inserted)
#
User 4
#
User 5
Configuration
#
User 6
#
3.11
Advertisement
Table of Contents
