Particular Managements; Gate Application; Users Configuration - Digicom Pocket AL I/O User Manual

Pocket AL I/O

5.1.4. Particular managements

1. AL standard application foresees the control of the alarm SMS number generated by the same contact, in case of malfunction
of an external sensor. This functionality is not enabled in the M2M application.
2. In the M2M application you can set a debounce between the detection of the input status change and the forwarding of the
notification SMS. Eventual other input status changes between the first detection and the SMS forwarding is ignored. The
management command is:
#TMTDEBOUNCE#n#
n is the number of tick (every 100ms). Admitted value from 2 (200ms) to 255; 10 is the dafault value, that is equal to 1000ms.
3. Besides the #TEST# command to test the inputs and output status, also the STATOALL command is supported (without "#"
characters).

5.2. GATE APPLICATION

With the GATE application, through the ring, you can modify an output status exceeding the limit of 6 users present in the AL
application. Only one output is managed but with the list of autorized users up to 80 users. This management is ideal for the
access control.
The command to enable this application is:
#GATE,output key#
NOTE: in this application the inputs are not managed. As well as for other applications the configuration
must be started by setting the keys #ACCLIST# and #0# (device ID).
The ring coming from enabled users will cause the temporary status change of the set output (1 second).
5.2.1. Users configuration
For the "user" configuration it is enough to send the following messages:
#Ux,telephone number# (x between 1 and 80)
Example
#U1,3351234567#
#U2,3359988776#
#U2,0#
To test the configuration:
#Ux?#
Pocket AL I/O will send back the single user configuration.
#U?#
Pocket AL I/O will send back all the users list and the key of the output associated to the GATE application.
5.2
Insertion/overwriting user 1
Insertion/overwriting user 2
Cancellation user 2
Pocket AL I/O Applications