Pocket AL I/O
5. POCKET AL I/O APPLICATIONS
Pocket AL I/O comes from Digicom know-how of PocketGSM AL and ArchimedeSMS; this allowed to identify the specific applications
of the new product. The applications "M2M" and "GATE" have been implemented to increase the performances of Pocket AL I/O
identified by "AL" application.
To enable one of the three applications you must send these comands:
#AL#
It enables the general application
Factory default
#M2M#
It enables the M2M application
#GATE,output key#
It enables the GATE application
Through the #CONFIG# command you can verify which application is active on Pocket AL I/O.
Attention: passing from an application to another will cause the device reset to factory configuration.
5.1. M2M APPLICATION
In this application a couple of Pocket AL I/O interacts without the presence of a user. After an input status change of the first device
a notification is sent directly to the second Pocket that will open or close the output.
The input of a Pocket will interact directly with the output of the second Pocket. It is really important that input and output are set
with the same ID.
The M2M application brings only a semplification of signalling messages in order Pocket can interprete the message and manage
the output.
ATTENTION: This kind of management requires a careful analysis of the application to avoid dangerous
malfunctions that may compromise the whole installation.
5.1.2. Alarm messages
After the detection of input status/transition change, Pocket AL I/O will send the following messages:
Device ID#input ID ON
Device ID#input ID OFF
5.1.3. Outputs management
Pocket AL I/O will modify the output status when it receives an SMS message as described in the previous paragraph.
After the output status change, a confirmation SMS is sent.
NOTE: It is very important that the phone number sending the SMS is set in the "User" authorized to modify
the output.
Pocket AL I/O Applications
5.1