Table of Contents
Advertisement
Pocket AL I/O
3.9. CONTACTS STATUS CHECK
During the operation the user can require the contacts status at any time to Pocket AL I/O.
To request it you must send and SMS to Pocket AL I/O with this format:
#TEST#
The TEST word can be written both in upper and lower case.
Furthermore with #TESTn# command (n has a value between 1 and 15) you can require the current status of n contact only. The
answer to #TESTn# command will describe the current status of the requested contact.
3.9.1. Device status forwarding
Once Pocket AL I/O receives the verification message of the #TEST# contacts status, it will send the status of all the contacts at
that moment. The message will have the following format:
• Pocket AL I/O ID
• Contact number
• ID associated to contact
• Contact status
ON : alarm condition
OFF : standard operating condition
• Battery status
BATTERY: FULL = back battery full
BATTERY: LOW = backup battery low
BATTERY: ABSENT = backup battery absent
BATTERY: CHARGING = backup battery charging (with power network)
• Device status
STATUS: ON = Pocket AL I/O enabled in operative status
STATUS: OFF = Pocket AL I/O disabled in Standby condition
Pocket AL I/O will send the current status of all the set contacts. If the requested information cannot be inserted in a sole SMS, it
will be necessary to send multiple SMS. The contacts that haven't been already set will not be inserted in the configuration.
Example of device status forwarding:
HOME
1)GasAlarm OFF
2)AntitheftAlarm OFF
4)GateAlarm OFF
5)GARAGE OFF
6)DOOR ON
7)OUTPUT3 OFF
8)OUTPUT4 OFF
11)OUTPUT5 OFF
12)OUTPUT6 OFF
13)Temperature 128
BATTERY: FULL
STATUS: ON
When Pocket AL I/O receives the #TESTn# message, it will send only the current status of the requested contact:
#TEST4#
HOME
4)GateAlarm OFF
Configuration
3.13
Advertisement
Table of Contents
