Table of Contents
Advertisement
Pocket AL I/O
1. INTRODUCTION
Congratulations for choosing Pocket AL I/O Digicom.
Pocket AL I/O is a signalling system via SMS equipped with a last
generation Dual-Band GSM/GPRS modem.
It can interface to different sensors according to your needs (i.e. gas,
allarms, fumes, water or level sensors, etc.) and then it sends you an SMS
at any change detected on each single sensor.
Furthermore you will be able to remote interact by sending appropriate
SMS that will pilot the opening/closing of the outputs.
Pocket AL I/O has been designed to operate with the networks of all the
GSM operators both directly and in roaming mode.
Pocket AL I/O complies with Class 4 (900 Mhz) and Class 1 (1800 Mhz).
1.1. TechnIcAL feATures
• Power supply
Power supply:
from 5 to 32 Vcc
• Temperature
Operating:
from -20°C to +55°C
Storage:
from -20°C to +70°C
• Connectors
Terminal board
6 PIN
Terminal board
20 PIN
Antenna
SMA female
SIM
Plug-In 3V and 1,8V (USIM are not supported)
Data
RS232 9 pin (V.24/V.28)
It allows to connect the device to the PC in order to set it up via serial port (it can be also setup via SMS
messages) and for firmware upgrades.
• Overall dimensions
Size
90x77x47mm
Weight
about 300 gr
1.2. PAckAge cOnTenT
• 1 Pocket AL I/O
• 1 GSM Antenna
• 1 User's Guide
screwless
Power
Two analog inputs
screwless
Four non optoinsulated digital inputs
Two optoinsulated digital inputs
Four open collector outputs
Two relay outputs (NO, C, NC)
Introduction
1.1
Advertisement
Table of Contents
