Configuring Address Pools - Cisco ASA 5505 Getting Started Manual

Chapter 7 Scenario: IPSec Remote-Access VPN Configuration

Configuring Address Pools

Step 1
Step 2
78-17612-02
For remote clients to gain access to your network, you must configure a pool of
IP addresses that can be assigned to remote VPN clients as they are successfully
connected. In this scenario, the pool is configured to use the range of IP addresses
209.165.201.1–209.166.201.20.
In Step 6 of the VPN Wizard, perform the following steps:
Enter a pool name or choose a preconfigured pool from the Name drop-down list.
Alternatively, click New to create a new address pool.
The Add IP Pool dialog box appears.
In the Add IP Pool dialog box, do the following:
Enter the Starting IP address and Ending IP address of the range.
a.
(Optional) Enter a subnet mask or choose a subnet mask for the range of IP
b.
addresses from the Subnet Mask drop-down list.
Click OK to return to Step 6 of the VPN Wizard.
c.
Implementing the IPSec Remote-Access VPN Scenario
Cisco ASA 5505 Getting Started Guide
7-11