Rear Panel Components - Cisco ASA 5505 Getting Started Manual

Ports and LEDs

Rear Panel Components

Port or LED
1
Power connector
2 Security service card slot
3 Serial console port
4
Lock device
5 RESET button
6
2 USB ports v2.0 ports
7 Ethernet switch ports 0–5
8 PoE switch ports 6–7
Cisco ASA 5505 Getting Started Guide
4-12
Figure 4-5 shows the back panel of the Cisco ASA 5505.
Figure 4-5 ASA 5505 Rear Panel
1 2
power
48
VDC
7
6
POWER over ETHERNET
8
Purpose
Attaching the power cord.
Reserved for future use.
Managing the device using the CLI (command-line interface).
Reserved for future use.
Reserved for future use.
Reserved for future use.
Layer 2 switch non-powered ports that provide flexible zone
configuration.
Can be used for PoE devices, that is, devices that can be powered by
the network interface, such as IP phones.
These ports are the only ports that can be used for IP phones, or
other PoE devices. However, these ports are not restricted to that
use. They can also be used as Ethernet switch ports, as are the ports
numbered 0 through 5.
If a PoE device is not attached, power is not supplied to the port, and
the device must be powered on its own.
Security
Services
Card Slot
5 4 3 2 1
7
Chapter 4 Installing the ASA 5505
3
Console
2
RESET
1
0
6
78-17612-02
4
5