About the Factory Default Configuration
•
•
By default, the adaptive security appliance Inside interface is configured with a
default DHCP address pool. This configuration enables a client on the inside network
to obtain a DHCP address from the adaptive security appliance to connect to the
appliance. Administrators can then configure and manage the adaptive security
appliance using ASDM.
For more information about CLI configuration, see the Cisco Security Appliance
Command Line Configuration Guide.
Cisco ASA 5505 Getting Started Guide
5-2
Security level of 100
–
Allocated switch ports Ethernet 0/1 through 0/7
–
IP address of 192.168.1.1 255.255.255.0
–
VLAN2 has the following properties:
Named "outside"
–
Allocated switch port Ethernet 0/0
–
–
Security level of 0
Configured to obtain its IP address using DHCP
–
Inside interface to connect to the device and use ASDM to complete your
configuration.
Chapter 5
Configuring the Adaptive Security Appliance
78-17612-02