Configuring The Adaptive Security Appliance; About The Factory Default Configuration - Cisco ASA 5505 Getting Started Manual

About the Factory Default Configuration

78-17612-02
Configuring the Adaptive Security
Appliance
This chapter describes the initial configuration of the adaptive security appliance.
You can perform the configuration steps using either the browser-based Cisco
Adaptive Security Device Manager (ASDM) or the command-line interface
(CLI). The procedures in this chapter describe how to configure the adaptive
security appliance using ASDM.
This chapter includes the following sections:
About the Factory Default Configuration, page 5-1
•
About the Adaptive Security Device Manager, page 5-3
•
Using the Startup Wizard, page 5-4
•
What to Do Next, page 5-7
•
Cisco adaptive security appliances are shipped with a factory-default configuration
that enables quick startup. The ASA 5505 comes preconfigured with
Two VLANs: VLAN 1 and VLAN2
•
VLAN 1 has the following properties:
•
Named "inside"
–
Allocated switch ports Ethernet 0/1 through Ethernet 0/7
–
C H A P T E R
Cisco ASA 5505 Getting Started Guide
5
5-1