Honeywell GSMX Installation And Setup Manual page 27

GSMX Installation and Setup Guide
Cell BaseSt
Chan
xxxxx x
xxx
Second Site
RSSI
-xxxdbm
[S]
ECP Flt
OK
[T]
Test Msg
Sent
[X]
Reset CPU
Y/N
[Shift]
Registering
...
[↑]
(UP
arrow)
[↓]
Enter PIN#
(DN
arrow)
GSM Status Display Screen 3
Cell – Base Station ID
BaseSt – Base Station Antenna Sector
Chan – Control Channel in use
Press the [Space] key to go to the next screen.
Press the [BS] key to go to the previous field.
GSM Status Display Screen 4
Secondary GSM Site RSSI level in dbm.
Press the [Space] key to go to the GSM Status
Display Screen 1.
Press the [backspace] key to go to the previous
field.
ECP Mode
Displays the mode of operation and system fault
status.
Flt – Represents communicator faults:
OK = Normal, No fault.
G = No network connectivity over GSM and fault
time has expired.
g = No network connectivity over GSM and fault
time has NOT yet expired.
Test Alarm
Sends a Test alarm to AlarmNet. Functional for
a registered GSMX only. If the device is not
registered, a message is displayed indicating
that the command cannot be executed.
Reset the GSMX.
Pressing [N] returns to normal mode.
Pressing [Y] resets the device.
Registration
Registers a programmed GSMX with AlarmNet.
Registration with PIN for Replacement
Module
Registers a replacement GSMX with AlarmNet,
once programmed, using the existing PIN #.
– 25 –